Until DJI finally give us some filters I’ve made this one to be 3D printed and it holds a 58mm standard circular Filter (55mm version added but I’ve not flown this one)

Caveat:

I accept no responsibility for you using this. For me it’s been working great with a 58mm Formatt Hitech Firecrest Ultra ND.

You will need to power up the drone without the holder attached because the gimbal fully rotates back on itself and this causes it to fail. So start up, then clip the attachment on.

It’s a bit heavier than the clear filter that ships with the drone however I’ve had no issues with the gimbal, even in sport mode.

You can’t tilt fully down 90degrees with it on.

Printer settings:

I printed in Bambulabs PLA-CF on standard settings. It needs to be strong for the little clips.

I printed with the little clips facing down towards the bed and with support on. It makes a very clean print

Finally, this took me about a day of prototyping. It will no doubt save you time and money and I’m fine with you modifying it. I’m not asking for payment but it would be nice if you made a donation to our supported charity if you are going to use this in your business.